Configuring a downstream FortiGate as an SP

There are two ways to configure the downstream FortiGate:

• From the root FortiGate
• From within the downstream device

An SP must be a member of the Security Fabric before you configure it.

To configure the downstream FortiGate from the root FortiGate:

1. Log in to the root FortiGate.
2. Go to Security Fabric > Fabric Connectors and double-click the Security Fabric Setup card.
3. In the Topology tree, hover over a FortiGate and click Configure.

   

   The Configure pane opens.

4. Enable SAML Single Sign-On. The Mode field is automatically populated as Service Provider (SP).
5. Enter an IP address in the Management IP/FQDN box.
6. Enter a management port in the Management port box.

   The Management IP/FQDN will be used by the IdP and so other SPs can redirect to each other. The Management port must be reachable from the user's device.

7. Select a Default login page option.
8. Select one of the following Default admin profile types: prof_admin, super_admin, or super_admin_readonly. The no_access_admin profile is set as the default.
9. Click OK.

   

To configure the downstream FortiGate within the device:

1. Log in to the downstream FortiGate.
2. Go to Security Fabric > Fabric Connectors and double-click the Security Fabric Setup card.
3. Enable SAML Single Sign-On. The Mode field is automatically populated as Service Provider (SP).
4. Enter an IP address in the Management IP/FQDN box.
5. Enter a management port in the Management port box.

   The Management IP/FQDN will be used by the IdP and so other SPs can redirect to each other. The Management port must be reachable from the user's device.

6. Select a Default login page option.
7. Select one of the following Default admin profile types: prof_admin, super_admin, or super_admin_readonly. The no_access_admin profile is set as the default.
8. Click OK.