Configuring SD-WAN in the CLI

This example can be entirely configured using the CLI.

To configure SD-WAN in the CLI:

1. Configure the wan1 and wan2 interfaces:

   config system interface 
       edit "wan1"
           set alias to_ISP1
           set mode dhcp
           set distance 10
       next
       edit "wan2"
           set alias to_ISP2
           set ip 10.100.20.1 255.255.255.0
       next
   end

2. Enable SD-WAN and add the interfaces as members:

   config system virtual-wan-link
       set status enable
       config members
           edit 1
               set interface "wan1"
           next
           edit 2
               set interface "wan2"
               set gateway 10.100.20.2
           next
       end
   end

3. Create a static route for SD-WAN:

   config router static
       edit 1
           set virtual-wan-link enable
       next
   end

4. Select the implicit SD-WAN algorithm:

   config system virtual-wan-link
       set load-balance-mode {source-ip-based | weight-based | source-dest-ip-based | measured-volume-based}
   end

5. Create a firewall policy for SD-WAN:

   config firewall policy
       edit <policy_id>
           set name <policy_name>
           set srcintf internal
           set dstintf virtual-wan-link
           set srcaddr all
           set dstaddr all
           set action accept
           set schedule always
           set service ALL
           set utm-status enable
           set ssl-ssh-profile <profile_name>
           set av-profile <profile_name>
           set webfilter-profile <profile_name>			
           set dnsfilter-profile <profile_name>
           set application-list <app_list>
           set logtraffic all
           set nat enable
           set status enable
       next
   end

6. Configure a performance SLA:

   config system virtual-wan-link
       config health-check
           edit "server"
               set server "208.91.112.53"
               set update-static-route enable
               set members 1 2
           next
       end
   end

Results

To view the routing table in the CLI:

# get router info routing-table all
 
Routing table for VRF=0
Codes: K - kernel, C - connected, S - static, R - RIP, B - BGP
       O - OSPF, IA - OSPF inter area
       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
       E1 - OSPF external type 1, E2 - OSPF external type 2
       i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
       * - candidate default
 
S*      0.0.0.0/0 [1/0] via 172.16.20.2, wan1
                  [1/0] via 10.100.20.2, wan2
C       10.100.20.0/24 is directly connected, wan2
C       172.16.20.2/24 is directly connected, wan1
C       192.168.0.0/24 is directly connected, internal

To diagnose the Performance SLA status:

FGT # diagnose sys virtual-wan-link health-check
Health Check(server):
Seq(1): state(alive), packet-loss(0.000%) latency(15.247), jitter(5.231) sla_map=0x0
Seq(2): state(alive), packet-loss(0.000%) latency(13.621), jitter(6.905) sla_map=0x0