Deploying FortiGate-VM HA with SDN connector
FortiGate-VM for Google Cloud Marketplace supports using the FortiGate Clustering Protocol (FGCP) in unicast form to provide an active-passive (A-P) high availability (HA) clustering solution for deployments in GCP. This feature shares a majority of the functionality, including configuration and session synchronization, that FGCP on FortiGate hardware provides with key changes to support GCP software-defined networking (SDN).
This solution works with two FortiGate instances configured as a primary and secondary pair, and requires that you deploy each instance with four network interfaces, within the same availability zone. These FortiGate instances act as a single logical instance and transfer interface Public IP addressing.
|
When deploying a FortiGate-VM HA cluster, choose a VM type that supports four or more network interfaces for each FortiGate-VM instance, as GCP does not allow adding network interfaces after you deploy the VMs. You can attach multiple network interfaces only when creating the VM instance on GCP. Two FortiGate-VM instances must be the same machine type. |
The main benefits of this solution are:
- Fast and stateful failover of FortiOS without external automation/services
- Automatic updates to route targets and IP addresses
- Native FortiOS session synchronization of firewall, IPsec/SSL VPN, and voice over IP sessions
- Native FortiOS configuration synchronization
- Ease of use as the cluster is treated as a single logical FortiGate
The following shows a network diagram of this deployment:
|
|
IPsec VPN phase 1 configuration does not synchronize between primary and secondary FortiGates across zones. Phase 2 configuration does synchronize. |
This example uses four networks for the described purposes:
|
Network |
Purpose |
|---|---|
|
Default network (subnet default) |
External Internet-facing network. This uses port1 on the FortiGate. |
|
VPC2 (subnet internal) |
Internal network where protected VMs are located. This uses port2 on the FortiGate. |
|
VPC3 (subnet 3) |
A subnet dedicated to the heartbeat between two FortiGates. This uses port3 on the FortiGate. |
|
VPC4 (subnet 4) |
A subnet dedicated to management access to the two FortiGates. This uses port4 on the FortiGate. |
The following summarizes minimum sufficient roles for active-passive high availability deployments:
- Compute Instance Admin (v1)
- Compute Network Admin
The following summarizes bash environment variables used in the following gcloud commands:
project=<GCP project ID>
zone1=<zone for fortigate-a or primary/active FortiGate>
zone2=<zone for fortigate-b or secondary/passive FortiGate>
reservedhaip=<HA Cluster IP to be moved in Failover event>
reservedfgtahamgmtip=<Public IP to manage fortigate-a >
reservedfgtbhamgmtip=<Public IP to manage fortigate-b >
serviceaccount=<your designated services account with correct permissions>
|
|
You must set the aforementioned variables in the Linux bash environment before you can use them in gcloud SDK commands. |
Check the prerequisites prior to attempting this deployment. This deployment method uses the SDN configuration that Configuring GCP SDN connector using metadata IAM describes.