online help

Home FortiConverter Tool 6.0.2 online help

6.0.2

Supported vendors and conversions

FortiConverter can translate configurations from the following vendors and models. Unless noted as an exception below, conversions only support IPv4 unicast policy.

If FortiConverter cannot properly translate some of the supported configurations listed from below table, please kindly contact our product support email alias fconvert_feedback@fortinet.com.

Vendor	Models	Versions	Convertible Objects
Alcatel-Lucent	Brick	ALSMS v9.x	Interface (physical, logical, loopback, PPPoE) Addresses & Address Books Partitions Services & Service Books Static Routes Zone rule set
Bluecoat	SGOS	6.5.10 6.7.4	Addresses & Address Groups Proxy Address (group) Service Proxy Policy
CheckPoint	SmartCenter	NGFP1 (4.0) to NGX R80	Interface Addresses & Address Groups Local Users & Groups NAT Negate Cell Policies (rulebases.fws/.csv) RADIUS, TACACS+, LDAP Rules (rulebases.fws/.csv) Schedules Services & Service Groups Static Routes VPN communities (IPSec site-to-site)
CheckPoint	Provider-1	NGX R65 to R80
Cisco	ASA	7.x/8.x/9.x	ACLs Addresses & Address Groups DHCP Servers DNS Servers Interface IP Pools Local Users & Groups NAT (Central NAT) RADIUS, TACACS+, LDAP Services & Service Groups Static Routes VPN
	FWSM	3.x/4.x
	IOS	10.x to 12.x
	IOS	15.x
	PIX	5.x/6.x/7.x/8.x
	Firepower	6.x
	IOS XR	4.x/5.x/6.x	Addresses & Address Groups & FQDNs Interface IPPools Policies Services & Service Groups Static Routes
	Nexus	5.2/6.x/7.x
FortiGate	FortiOS	FOS5.2 and above	FortiGate configuration can be converted based on the version of the target FortiGate device (We suggest to migrate to FortiOS 6.0 and above). However, note that Older features might be deprecated and may not be fully converted over. The review is necessary. After importing the converted configuration, any CLI commands that have not successfully imported can be reviewed on the page. For more details, please see "FortiGate configuration migration" and "Reviewing errors after FortiGate import "sections in admin guide.
Huawei	USG Series		Interface Zone Addresses & Address Groups Services & Service Groups Policy Route Zone IPSec Policy (VPN) Security Context Nat Policy (SNAT) Nat Server (VIP)
IBM	PAM		IPS Sensor
Juniper	SSG/ISG	ScreenOS 4.x, 5.x, 6.x	Addresses & Address Groups & FQDNs DHCP Servers & Clients & Relays Interfaces Static Routes Services & Service Groups Policies VIPs/MIPs NAT IP Pools VPN Local Users & Groups RADIUS & LDAP Zones
	SRX	JunosOS 10.x to 18.x	Addresses & Address Groups & FQDNs DHCP Servers & Client & Relay Interfaces IP Pools Local Users & Groups NAT Policies RADIUS & LDAP Services & Service Groups Static Routes VIPs/MIPs VPN (IPSec site-to-site) Zones Routing-instances (virtual-router)
	MX	Juno OS 10.x to 12.x	Addresses & Address Groups & FQDNs Interfaces IP Pools Policies Services & Service Groups Static Routes
McAfee	Sidewinder	7.x, 8.x	Addresses & Address Groups & FQDNs Interfaces IP Pools Policies Services & Service Groups Static Routes
Forcepoint	Stonesoft	5.7- 6.7	Addresses & Address Groups Interfaces Policies/ Sub-policy Alias Services & Service Groups Static Routes NAT
Palo Alto Networks	PAN OS	PAN-OS 1.x to 8.x	Addresses & Address Groups & FQDNs Interfaces Local Users & Groups NAT Policies Schedules Static Routes Services & Service Groups Zones VPN Panorama
Snort			IPS rules
SonicWall	TZ Series NSA Series	SonicOS 4.x, 5.x, 6.x	Addresses & Address Groups & FQDNs DHCP Servers & Clients & Relays Interfaces Local Users & Groups NAT Policies Schedules Services & Service Groups Static Routes Zones VPN (IPSEC site to site) SSLVPN
Sophos	XG Series	SFOS 17.0 - 17.5 MR3	Interface Zone Addresses & Address Groups Service & Service Groups Users & User Groups Policy
Sophos	Cyberoam	Cyberoam OS 10.6.3 onward
Tipping Point	IPS	4.5	Addresses & Address Groups Policies Services & Service Groups
Vytta	VyOS	5.2 to 6.7	Interface Zone Addresses & Address Groups Services & Service Groups Policy Route
WatchGuard	Firebox Series XTM Series	Fireware 11.3 to 12.6	Interfaces Addresses & Address Groups Services & Service Groups Policies Static Routes IPSec VPN NAT

Exception

Check Point to FGT conversion can support IPv4 multicast policy.
Check Point, Cisco, and Juniper (Junos only) to FGT conversion can support IPv6 unicast policy.

Supported vendors and conversions

FortiConverter can translate configurations from the following vendors and models. Unless noted as an exception below, conversions only support IPv4 unicast policy.

If FortiConverter cannot properly translate some of the supported configurations listed from below table, please kindly contact our product support email alias fconvert_feedback@fortinet.com.

Vendor	Models	Versions	Convertible Objects
Alcatel-Lucent	Brick	ALSMS v9.x	Interface (physical, logical, loopback, PPPoE) Addresses & Address Books Partitions Services & Service Books Static Routes Zone rule set
Bluecoat	SGOS	6.5.10 6.7.4	Addresses & Address Groups Proxy Address (group) Service Proxy Policy
CheckPoint	SmartCenter	NGFP1 (4.0) to NGX R80	Interface Addresses & Address Groups Local Users & Groups NAT Negate Cell Policies (rulebases.fws/.csv) RADIUS, TACACS+, LDAP Rules (rulebases.fws/.csv) Schedules Services & Service Groups Static Routes VPN communities (IPSec site-to-site)
CheckPoint	Provider-1	NGX R65 to R80
Cisco	ASA	7.x/8.x/9.x	ACLs Addresses & Address Groups DHCP Servers DNS Servers Interface IP Pools Local Users & Groups NAT (Central NAT) RADIUS, TACACS+, LDAP Services & Service Groups Static Routes VPN
	FWSM	3.x/4.x
	IOS	10.x to 12.x
	IOS	15.x
	PIX	5.x/6.x/7.x/8.x
	Firepower	6.x
	IOS XR	4.x/5.x/6.x	Addresses & Address Groups & FQDNs Interface IPPools Policies Services & Service Groups Static Routes
	Nexus	5.2/6.x/7.x
FortiGate	FortiOS	FOS5.2 and above	FortiGate configuration can be converted based on the version of the target FortiGate device (We suggest to migrate to FortiOS 6.0 and above). However, note that Older features might be deprecated and may not be fully converted over. The review is necessary. After importing the converted configuration, any CLI commands that have not successfully imported can be reviewed on the page. For more details, please see "FortiGate configuration migration" and "Reviewing errors after FortiGate import "sections in admin guide.
Huawei	USG Series		Interface Zone Addresses & Address Groups Services & Service Groups Policy Route Zone IPSec Policy (VPN) Security Context Nat Policy (SNAT) Nat Server (VIP)
IBM	PAM		IPS Sensor
Juniper	SSG/ISG	ScreenOS 4.x, 5.x, 6.x	Addresses & Address Groups & FQDNs DHCP Servers & Clients & Relays Interfaces Static Routes Services & Service Groups Policies VIPs/MIPs NAT IP Pools VPN Local Users & Groups RADIUS & LDAP Zones
	SRX	JunosOS 10.x to 18.x	Addresses & Address Groups & FQDNs DHCP Servers & Client & Relay Interfaces IP Pools Local Users & Groups NAT Policies RADIUS & LDAP Services & Service Groups Static Routes VIPs/MIPs VPN (IPSec site-to-site) Zones Routing-instances (virtual-router)
	MX	Juno OS 10.x to 12.x	Addresses & Address Groups & FQDNs Interfaces IP Pools Policies Services & Service Groups Static Routes
McAfee	Sidewinder	7.x, 8.x	Addresses & Address Groups & FQDNs Interfaces IP Pools Policies Services & Service Groups Static Routes
Forcepoint	Stonesoft	5.7- 6.7	Addresses & Address Groups Interfaces Policies/ Sub-policy Alias Services & Service Groups Static Routes NAT
Palo Alto Networks	PAN OS	PAN-OS 1.x to 8.x	Addresses & Address Groups & FQDNs Interfaces Local Users & Groups NAT Policies Schedules Static Routes Services & Service Groups Zones VPN Panorama
Snort			IPS rules
SonicWall	TZ Series NSA Series	SonicOS 4.x, 5.x, 6.x	Addresses & Address Groups & FQDNs DHCP Servers & Clients & Relays Interfaces Local Users & Groups NAT Policies Schedules Services & Service Groups Static Routes Zones VPN (IPSEC site to site) SSLVPN
Sophos	XG Series	SFOS 17.0 - 17.5 MR3	Interface Zone Addresses & Address Groups Service & Service Groups Users & User Groups Policy
Sophos	Cyberoam	Cyberoam OS 10.6.3 onward
Tipping Point	IPS	4.5	Addresses & Address Groups Policies Services & Service Groups
Vytta	VyOS	5.2 to 6.7	Interface Zone Addresses & Address Groups Services & Service Groups Policy Route
WatchGuard	Firebox Series XTM Series	Fireware 11.3 to 12.6	Interfaces Addresses & Address Groups Services & Service Groups Policies Static Routes IPSec VPN NAT

Exception

Check Point to FGT conversion can support IPv4 multicast policy.
Check Point, Cisco, and Juniper (Junos only) to FGT conversion can support IPv6 unicast policy.

Secure Networking

Hybrid Mesh Firewall

NOC Management

LAN

WAN

Unified SASE

Single Vendor SASE

Cloud Network Security

Secure Endpoint Connectivity

Web Application / API Protection

Security Operations

Security Operations Automation

Identity

Early Detection & Prevention

Secure Networking

Hybrid Mesh Firewall

NOC Management

LAN

WAN

Communication & Surveillance

Unified SASE

Single Vendor SASE

Secure Endpoint Connectivity

Cloud Network Security

Cloud-Native Security

Web Application / API Protection

Security Operations

Security Operations Automation

Endpoint

Data Protection

Identity

Email

Early Detection & Prevention

Expert Services

Edge Firewall

Orchestration & management

SD Branch

Application Delivery

Single Vendor SASE

Secure Endpoint Connectivity

Secure Private Access

Thin Edge

Identity

Application Gateway

Enterprise Asset Management

Endpoint Agent

Agentless Security Posture

Identity

Wireless

Switching

Identity

Privilege Acccess Management

Next Generation Firewall

Orchestration & management

Expert Services

All

All

Account Management

SAAS Management

SAAS Application Security

Managed Services

Platform as a service (PAAS)

Other SAAS Services

4D Pillars

Cloud

Popular Solutions

online help

Supported vendors and conversions

Supported vendors and conversions

Exception

Supported vendors and conversions

Supported vendors and conversions

Exception