Endpoint: Remote Access
This section lists the new features added to FortiClient and EMS for endpoint remote access:
- Selecting closest gateway for VPN connection
- VPN autoconnect/always up logic improvement
- Support load balancing SSL VPN gateways with one FQDN
- Network lockdown for off-fabric endpoints 7.2.1
- IPsec VPN connection enhancements 7.2.1
- Support certificate path configuration for automated certificate selection 7.2.1
- Support for encryption recommended by NCSC 7.2.2
- SSL VPN DTLS support for FortiClient (macOS) and (Linux) 7.2.2
- Split DNS support for FortiClient (Linux) SSL VPN 7.2.2
- Secure remote access compliance enforcement 7.2.3
- Support for IKEv2 for FortiClient (macOS) 7.2.3
- Support autoconnect to IPsec VPN using Entra ID logon session information 7.2.3
- Prioritize IPsec VPN and ZTNA for remote access over SSL VPN 7.2.3
- Split DNS support for IPsec VPN 7.2.3
- IPsec VPN SAML-based authentication 7.2.4
- IPsec VPN support for traffic going through FortiADC 7.2.4
- Source IP address anchoring for IPsec VPN 7.2.4
- Prioritize IPsec VPN and ZTNA for remote access over SSL VPN 7.2.5
- IPsec VPN with FortiToken Mobile push MFA 7.2.5
- SAML authentication for VPN before logon 7.2.5
- IPsec VPN support network lockdown and hotel mode 7.2.5
- Dual stack IPv4 and IPv6 support on FortiClient (Linux) 7.2.5