Connecting to the FortiAnalyzer console

To connect to the FortiAnalyzer console, you need:

• a computer with an available communications port
• a console cable, provided with your FortiAnalyzer unit, to connect the FortiAnalyzer console port to a communications port on your computer
• terminal emulation software, such as HyperTerminal for Windows.

The following procedure describes how to connect to the FortiAnalyzer CLI using Windows HyperTerminal software. You can use any terminal emulation program.

To connect to the CLI:

1. Connect the FortiAnalyzer console port to the available communications port on your computer.
2. Make sure that the FortiAnalyzer unit is powered on.
3. Start a terminal emulation program on the management computer, select the COM port, and use the following settings:

   COM port	COM1
   Baud rate	9600
   Data bits	8
   Parity	None
   Stop bits	1
   Flow control	None

4. Press Enter to connect to the FortiAnalyzer CLI.
5. In the log in prompt, enter the username and password.

   The default log in is username: admin, and no password.

   A password policy is enabled by default in FortiAnalyzer 7.6.4 and later. The new password must be at least 8 characters and must contain uppercase letter(s), lowercase letter(s), number(s), and special character(s). Once you have accessed the CLI, you can update configuration for the password policy as needed using config system password-policy. For more information, see password-policy.

   You have connected to the FortiAnalyzer CLI, and you can enter CLI commands.