Deploying FortiAIOps 100G (FAO-100G)
The FAO-100G hardware platform comes with FortiAIOps pre-installed. Perform the following steps to deploy and configure the device.
Initial Configuration
After setting up and mounting the appliance on the rack, connect to the FortiAIOps 100G CLI using the console port and perform the following steps. See, FortiAIOps 100G Quick Start Guide.
-
On the console Log in as an admin user with the username admin. A password is not required. You will be prompted to configure a new password after the initial login.
This CLI password is same as the GUI password. The default username for logging into GUI is admin and there is no password.
-
Verify the dynamically assigned IP address using the command:
get system interface -
Configure a static IP address (recommended) using the command:
config system interface
For a complete list of supported CLI commands, see Command Line Interface (CLI) Reference.
Accessing the GUI
After completing the initial CLI configuration, you can access the FortiAIOps GUI.
-
Open a web browser and enter the following URL.
https://<fortiaiops_server_IP>Replace
<fortiaiops_server_IP>with the static IP address you configured. -
Log in using the default GUI credentials. Enter the username as admin. There is no password for the initial login.
Supported Devices
The following are the maximum devices supported in FortiAIOps 100G hardware.
|
Maximum device count |
Supported Mode |
|---|---|
|
AI Insights and Monitoring |
|
Monitoring only |