config system servicegrp
Use this command to create the service group objects that you use to specify matching services in policies.
The following policies use service group objects:
- Link Load Balance policies
Basic Steps
- Create service group objects.
- Specify them when you configure your policies.
Before you begin:
- You must have read-write permission for system settings.
- You must have created service objects.
Syntax
config system servicegrp
edit "servicegrp-name"
set member-list <A> <B> <C>
end
|
servicegrp-name |
The name of the service-group. |
member-list
|
List of supported system services, which include the following:
|
Example
config system service
edit "http"
set protoco-type tcp
set specify-source-port enable
set source-port-min 1
set source-port-max 65535
set destination-port-min 80
set destination-port-max 80
next
edit "icmp"
set protoco-type icmp
next
end
config system servicegrp
edit "servicegrp_test"
set member-list HTTP ICMP
next
end
config system addrgrp
edit "1"
set member-list 10_10 10_20
next
end
config system addrgrp6
edit "v6_1"
set member-list v6_10 v6_20
next
end