config log setting highspeed

Use this command to configure high speed logging.

The high speed log feature is intended for deployments that require a high volume of logging activity. The logs are sent in binary format so they can be sent at a high speed. If you want to use high speed logging, contact Fortinet to obtain a utility for handling the binary format.

The feature supports traffic logs. Event logs and security logs are not supported.

Before you begin:

• You must have read-write permission for log settings.

Syntax

config log setting highspeed

set server <string>

set status {enable | disable}

set traffic-log-status {enable | disable}

set traffic-log-category {slb|dns}

set udpport <integer>

end

server	IP address of the syslog server.
status	Enable/disable the configuration.
traffic-log-status	Enable/disable logging for traffic processed by the load balancing modules.
traffic-log-category	slb—Send server load balancing logs. dns—Send global load balancing logs.
udpport	Listening port number of the syslog server. Usually this is UDP port 514.