config firewall policy6

Use this command to configure firewall policy rules for IPv6 addresses.

A firewall policy is a filter that allows or denies traffic to be forwarded to the system based on a matching tuple: source address, destination address, and service. By default, firewall policy rules are stateful: if client-to-server traffic is allowed, the session is maintained in a state table, and the response traffic is allowed.

The FortiADC system evaluates firewall policies before other rules. It matches traffic against the firewall policy table, beginning with the first rule. If a rule matches, the specified action is taken. If the session is denied by a firewall policy rule, it is dropped. If the session is accepted, system processing continues.

By default, if firewall rules are not configured, the system does not perform firewall processing; all traffic is processed as if the system were a router, and traffic is forwarded according to routing and other system rules.

Note: You do not need to create firewall rules for routine management traffic associated with the management port or HA ports. The interface “allow access” option enables permitted protocols. The system automatically permits from-self traffic, such as health check traffic, and expected responses.

Before you begin:

• You must have a good understanding and knowledge of firewalls.
• You must have created the address configuration objects and service configuration objects that define the matching tuple in your firewall policy rules.
• You must have read-write permission for firewall settings.

Syntax

config firewall policy6

set default-action {deny|accept}

set stateful {enable|disable}

config rule

edit <name>

set action {deny | accept}

set deny-log {disable | enable}

set destination-address6 <datasource>

set in-interface <datasource>

set out-interface <datasource>

set service <datasource>

set source-address6 <datasource>

set status {enable | disable}

next

end

end

default-action	Action when no rule matches or no rules are configured: deny—Drop the traffic. accept—Allow the traffic to pass the firewall.
stateful	Enable/disable stateful firewall. When enabled, server response traffic is permitted automatically when the client-to-server rule allows the connection to be established. When disabled, you must create separate rules for client-to-server and server-to-client traffic. Enabled by default.
config rule
action	deny—Drop the traffic. accept—Allow the traffic to pass the firewall.
deny-log	Enable/disable deny log. When enabled, firewall denied traffic is logged, wherein relevant information for traffic is logged when the traffic triggers the policy action to drop it. The deny-log option is only available when action is set to deny. Disabled by default.
destination-address6	Destination address/addressbook object used to form the matching touple.
in-interface	Interface that receives traffic.
out-interface	Interface that forwards traffic.
service	Service object to use to form the matching tuple.
source-address6	Source address/addressbook object used to form the matching touple.
status	Enable or disable firewall policy6 rule.