Configuring HTTP access limit policy
HTTP Access Limit policy can limit the speed of HTTP request from a source IP.
Before you begin:
- You must have Read-Write permission for Security settings.
After you have configured HTTP Access Limit policies, you can select them in DoS Protection Profile.
To configure a HTTP Access Limit policy:
- Go to DoS Protection > Application > HTTP Access Limit.
- Click Create New to display the configuration editor.
Complete the configuration.
Configuration name. Valid characters are A-Z, a-z, 0-9, _, and -. No spaces.
Enable | Disable. If Enable, this policy will be activated, otherwise it is inactive.
HTTP Request Limit
0-65535. Limits the amount of HTTP requests per second from a certain IP. 0 means no limit for HTTP request.
Pass—Allow the traffic.
Deny— Drop the traffic, send a 400 Bad request to the client.
Period Block—Deny all the HTTP request from a source IP within a period which specified by Period Block.
1-3600 seconds; Default: 60
Enable | Disable; If Enable the Action will be log
High—Log as high severity events.
Medium—Log as a medium severity events.
Low—Log as low severity events.
The default value is High.
- Save the configuration.