Applying the branch configuration

Use this procedure to apply the branch configuration from the main office FortiVoice phone system to the FortiVoice LSG unit and if present, its associated FortiVoice FXS gateway.

Prior to applying the configuration file, make sure that the FortiVoice phone system and FortiVoice LSG unit (and FXS gateway, if present) are running the 6.0.x firmware version. Supported setup examples for Apply Configuration: FortiVoice 6.0.12 with FortiVoice LSG (and FXS gateway, if present) 6.0.11 or 6.0.12 FortiVoice 6.0.11 with FortiVoice LSG (and FXS gateway, if present) 6.0.12 Unsupported setup example for Apply Configuration: FortiVoice 6.4.7 with FortiVoice LSG (and FXS gateway, if present) 6.0.11 or 6.0.12 To verify the firmware version, go to Dashboard > Status. In the System Information widget, go to Firmware version.

1. Connect to the GUI of the primary FortiVoice phone system at the main office.
2. Go to Managed System > Survivability.
3. On the Survivability Branch tab, select the branch to which you want to apply the configuration.
4. Click Apply Configuration.

   If the FXS gateway is not linked to a survivability branch, a dialog box displays the following message:

   Do you really want to update selected gateway?

   If the FXS gateway is linked to a survivability branch, a dialog box displays the following message:

   The config would be applied to both LSG and GW's. Do you really want to update selected gateway?

5. To confirm, click OK.

   When the configuration changes are complete, a dialog box displays the following message:

   Gateway upgrade finished.

6. Click OK.

   You have applied the branch configuration.

7. Continue with Verifying the heartbeat status.