Creating an additional trunk profile for a FortiVoice Gateway GT02
A FortiVoice Gateway GT02 has two spans, one for each PRI port. By default, both PRI spans are mapped to a single trunk. However, you can reassign a span to a second trunk, if required.
To create an additional trunk profile, perform this procedure.
Prerequisite
|
Before adding any span to a trunk, make sure to free the span in the default trunk. For more details, see Editing a trunk profile for a PRI gateway. |
Procedure steps
- In the web-based manager of the FortiVoice phone system, go to Trunks > Gateways.
- Click New.
- Configure the following settings:
GUI field
Description
Trunk gateway
Enter a unique name for this trunk profile.
Enabled
Select to activate this trunk profile.
Type
Select PRI.
Display name
Not required. You can leave this field empty.
Main number
Not required. You can leave this field empty.
If you want, you can add a main number for reference. For example, you can use the number assigned by your service provider to identify the trunk.
Span
Click the link next to Span.
Select the trunk profile in the Available list and click -> to move the trunk to the Selected list.
Gateway device
Select the device type for this profile.
Gateway SIP address
Enter the SIP address of the gateway.
Gateway SIP port
Enter the SIP port number of the gateway.
This port number is 5060 or 5061.
Caller ID modification
Optionally, select the caller ID modification configuration. This choice changes the phone number, caller name, or both that display on the destination phone.
For more details, see the Modifying caller IDs section in the FortiVoice Phone System Administration Guide.
Relay fax
Select to allow this gateway to receive and send faxes.
Description
Optionally, add notes for this trunk profile.
- To save changes, click Create.
- Send the configuration changes to the PRI gateway by following the instructions in Applying the PRI gateway configuration.