Starting an HTTPS CC test

The HTTPS CC test is the same as the HTTP CC test, except that it uses HTTPS traffic and the MTU is editable.

To start an HTTPS CC test:

1. In Performance testing, expand HTTPS and click CC.
2. Click Create New.
3. Configure the network or select a network template. See Using network configuration templates for how to create a network template.
4. Select a Certificate Group, if applicable.
5. Click OK.
6. Configure the test case options described below.
7. Click Start to run the test case.

FortiTester saves the configuration automatically so you can run the test again later. You can also click Save to save the test case without running it.

Tip 1: You can copy an existing case and change its settings to create a new case. In the case list, click Clone to clone the configuration. Only the case name is different from the original case. Tip 2: You can add or edit a comment when the test is running. This comment can be used to search for the test result in the Results page. This is useful especially when the test runs for a long time.

HTTPS CC test case options

For details about the common options for HTTPS cases, see HTTPS test case common options.

Settings	Guidelines
Load
Maximum Concurrent Connections	Determines the maximum number of concurrent TCP connections supported through or with the DUT/SUT. This test is intended to find the maximum number of entries the DUT/SUT can store in its connection table.
Think Time	The delay between client HTTP requests (unit: second).