Starting an RFC 2544 loss rate test
FortiTester tests the ability of the DUT to handle different types of RFC 2544 loss rate. According to RFC2544, to determine the frame loss rate, as defined in RFC1242 of a DUT throughout the entire range of input data rates and frame sizes.
To start an RFC 2544 loss rate test:
- In Performance testing, expand RFC 2544 and click loss rate.
- Click Create New.
- Configure the network or select a network template. See Using network configuration templates for how to create a network template.
- Select a Certificate Group, if applicable.
- Click OK.
- Configure the test case options described below.
- Click Start to run the test case.
FortiTester saves the configuration automatically so you can run the test again later. You can also click Save to save the test case without running it.
|
Tip 1: You can copy an existing case and change its settings to create a new case. In the case list, click Clone to clone the configuration. Only the case name is different from the original case. Tip 2: You can add or edit a comment when the test is running. This comment can be used to search for the test result in the Results page. This is useful especially when the test runs for a long time. |
RFC 2544 loss rate test case options
For details about the common options for RFC 2544 cases, see RFC Test Case common options .
| Settings | Guidelines |
|---|---|
| Load | |
| Up/Down Granularity | Custom Load only. Traffic speed per cycle. 0 means sending speed in the next traffic cycle is equal to "Receive Mbps" in the previous cycle. 1 - 20 is the sending speed float percentage of maximum speed in the next cycle. |
| Correct Loss Rate Cycle | Custom Load only. Set to 1. Not configurable. |