Single Packets
The single packet defines the packet proportion that can be used in single packet groups.
To create a Single Packet:
- Go to Security Testing > Objects > Single Packets.
- Click + Create New to display the configuration page.
- Configure the following settings:
-
IP Version—The IP Version of your packet type. Note: ARP is IPv4 only.
IP Parameters
IPv4 DSCP: 0 - 63
Identification: set value or random
TTL: 1 - 255
DF: 0 - 1
MF: 0 - 1
Fragment Offset: 0 - 8189
IPv6 DSCP: 0 - 63
Hop Limit: 1 - 255
Fragment: toggle on/off
Fragment Offset (if fragment): 0 - 8191
-
Packet Type
ARP SMAC address prefix: xx-xx (the rest generated randomly),
Note: IPv4 only.
DNS Query IP parameters
UDP parameters (see UDP type) but omit payload and payload size range.
Domain
Subdomain: specify or random
GRE/UDP Outer IP parameters
Inner IP parameters
UDP parameters (see UDP below)
ICMP IP parameters
Payload Size: fixed value or range
Message type: Echo
TCP IP parameters
Source Port: fixed value or range, available range 1 - 65,535
Destination Port: fixed value or range, available range 1 - 65,535
Payload Size: fixed value or range
Flags: SYN, ACK, PSH, RST, FIN, URG, CWR, ECE (toggle on/off)
UDP
IP parameters
Source port: fixed value or range, available range 1 - 65,535
Destination port: fixed value or range, available range 1 - 65,535
Payload: random or VSE
Payload size (if random payload): fixed value or range
IPv4 UDP checksum: toggle on/off