Diagnostic monitoring interface module status
With the diagnostic monitoring interface (DMI), you can view the following information
- Module details (detail)
- Eeprom contents (eeprom)
- Module limits (limit)
- Module status (status)
- Summary information of all a port’s modules (summary)
Using the GUI:
Go to Switch > Monitor > Modules.
Using the CLI:
Use the following commands to enable or disable DMI status for the port. If you set the status to global, the port setting will match the global setting:
config switch physical-port
edit <interface>
set dmi-status {disable | enable | global}
end
Use the get switch modules detail/status command to display DMI information:
S148FNTF20000098 # get switch modules detail port50 ____________________________________________________________ Port(port50) identifier SFP/SFP+ connector Unk(0x00) transceiver 1000-Base-T encoding 8B/10B Length Decode Common length_smf_1km N/A length_cable 100 meter SFP Specific length_smf_100m N/A length_50um_om2 N/A length_62um_om1 N/A length_50um_om3 N/A vendor FINISAR CORP. vendor_oid 0x009065 vendor_pn FCLF-8521-3 vendor_rev vendor_sn PU71L2H manuf_date 08/15/2015
The following is an example of the output for the get switch modules status command:
FS1E48T419000004 # get switch modules status port50 ____________________________________________________________ Port(port50) temperature 23.957031 C voltage 3.293100 volts alarm_flags[0] 0x0000 warning_flags[0] 0x0000 laser_bias[0] 0.761600 mAmps tx_power[0] -2.246809 dBm rx_power[0] -2.926854 dBm alarm_flags[1] 0x0000 warning_flags[1] 0x0000 laser_bias[1] 0.755200 mAmps tx_power[1] -1.993517 dBm rx_power[1] -3.300326 dBm alarm_flags[2] 0x0000 warning_flags[2] 0x0000 laser_bias[2] 0.761600 mAmps tx_power[2] -2.105603 dBm rx_power[2] -2.486439 dBm alarm_flags[3] 0x0000 warning_flags[3] 0x0000 laser_bias[3] 0.748800 mAmps tx_power[3] -2.128939 dBm rx_power[3] -2.641617 dBm options 0x000F ( TX_DISABLE TX_FAULT RX_LOSS TX_POWER_LEVEL1 ) options_status 0x0008 ( TX_POWER_LEVEL1 )