Discovering
This section covers the following topics:
Authorizing
If automatic authorization is disabled, you need to authorize the FortiSwitch unit as a managed switch:
config switch-controller managed-switch
edit FS224D3W14000370
set fsw-wan1-admin enable
end
end
NOTE: After authorization, the FortiSwitch unit reboots in managed mode.
Preparing the FortiSwitch unit
If the FortiSwitch unit is in the factory default configuration, it is ready to be connected to FortiSwitch Manager. If the FortiSwitch unit is not in the factory default configuration, log in to the FortiSwitch unit with the CLI and use the execute factoryreset command to reset the FortiSwitch unit to the factory defaults