- What is Discovered and Monitored
- Event Types
- Settings for Access Credentials
|SNMP (V1, V2c)
|Host name, Serial number, Software version, Hardware model, Network interfaces, Hardware Components
|Uptime, Network Interface metrics (utilization, bytes sent and received, packets sent and received, errors, discards and queue lengths), CPU utilization, Memory utilization, Flash utilization, Hardware Status
|Availability and Performance Monitoring
|Running and Startup configurations
|Startup Configuration Change, Difference between Running and Startup configurations
There are no event types defined specifically for this device.
There are no predefined rules for this device.
There are no predefined reports for this device.
FortiSIEM uses Telnet/SSH to communicate with this device. Refer to the product documentation for your device to enable Telnet/SSH.
These commands are used for discovery and performance monitoring via SSH. Please make sure that the access credentials you provide in FortiSIEM have the permissions necessary to execute these commands on the device.
show ip route
terminal pager 0
FortiSIEM uses SNMP to discover and monitor this device. Make sure SNMP is enabled for the device as directed in its product documentation.
You can configure FortiSIEM to communicate with your device, and then initiate discovery of the device. For more information, refer to sections "Discovery Settings" and "Setting Credentials" in the User Guide.
Set these Access Method Definition values to allow FortiSIEM to communicate with your device over SNMP. Set the Name and Community String.
These are the generic settings for providing Telnet access to your device from FortiSIEM.
|A user who has permission to access the device over Telnet
|The password associated with the user
These are the generic settings for providing SSH access to your device from FortiSIEM.
|A user who has access credentials for your device over SSH
|The password for the user