hc-primary

Configure the unit as a HA-Cluster primary unit.

syntax

hc-primary [-h|-l|-r|-sg|-u|-s|-e|-d|-si|-i|-a|-r|-so|-a|-p|-m]

Option	Description
-h (or --help)	Help information.
-l	Show current configuration.
-r <unit sn>	Remove a secondary or worker unit from the cluster by its serial number.
-sg	General settings. Option Description -u Turn off file scans on the primary unit. -s<10–100> Turn on file scans on the primary unit with 10%–100% processing capacity. -e Enable encrypted traffic between HA cluster members. -d Disable encrypted traffic between HA cluster members.
-si	Configure external IP addresses for the cluster. Option Description -i <interface> Specify the interface used for external communication. -a <IP/netmask> Add an external IP address to the specified interface. The IP will be configured as an alias IP and must be in the same subnet as the interface IP. -r <IP/netmask> Remove an external IP address from the specified interface.
-so	Set/Unset HA mode of the cluster (Available on Primary only). Option Description -a Set Primary and Secondary units to Active-Active mode. -p Set Primary and Secondary units to Active-Passive mode. -m Set Primary and Secondary units to Cluster Management mode