Static routes
To see a list of static routes that control the flow of traffic through the unit, go to Network > Static Routing
Hover over the leftmost edge of the column heading to display the Configure Table icon, which you can use to select the columns to display or to reset all the columns to their default settings. You can also drag column headings to change their order.
The following options are available:
|
Create New |
Creates an IPv4 or IPv6 static route. See Create or edit a static route. |
|
Edit |
Modifies settings within the static route. See Create or edit a static route. |
|
Clone |
Copies an existing route. |
|
Delete |
Removes a static route from the list. To remove multiple static routes, select multiple rows in the list by holding down the Ctrl or Shift keys and then select Delete. |
|
Search |
Enter a search term to find in the list. |
|
Destination |
The destination IP addresses and network masks of packets that the FortiProxy unit intercepts. |
|
Gateway IP |
The IP addresses of the next-hop routers to which intercepted packets are forwarded. |
|
Interface |
The interface or port number the static route is configured to. |
|
Status |
The static route is either enabled or disabled. |
|
Comments |
A description of the route (optional). |
|
Distance |
The number of hops the static route has to the configured gateway. Routes with the same distance will be considered as equal-cost multi-path (ECMP) |
|
Priority |
A number for the priority of the static route. Routes with a larger number will have a lower priority. Routes with the same priority are considered as ECMP. |