Blocked hosts
If you enable blocked hosts as a global setting in General, the system enforces a configurable blocklist for all admin and users.
Configure blocked IP addresses in the Blocked Hosts tab.
|
The blocklist is a system level feature, and it applies to SSO and SAML users. |
To create a blocked host:
-
Go to System > Settings > Blocked Hosts.
Select a blocked host and then click Edit to edit the blocked host.
When editing a blocked host, the fields are the same as those that appear when creating a blocked host.
- In the Blocked Hosts tab, click Create.
The Create Blocked Hosts window opens.
- Enter the following information:
-
Field
Required
Description
Type
Y
Select IPv4 or IPv6.
IP Start
Y
Enter the start address for the range covered by this entry.
Mask
Y
If Type is set to IPv4, define the range of IP addresses covered by this entry.
Prefix
Y
If Type is set to IPv6, define the range of IP addresses covered by this entry.
- Click Save.
|
|
To delete one or more blocked hosts, select the hosts and click Delete. |