Creating an address group
To create an address group:
- Go to Authentication > Addresses.
- From the +Create New dropdown, select Address Group.
- Enter the following information:
Category
Select from the following options:
IPv4 Group
Proxy Group
Group name
Name of the group.
Color
Select Change, and from the color palette choose a color.
Type
For an IPv4 group, select either Group or Folder.
For a proxy group, select either Source Group or Destination Group.
Members of the address folders can only belong to a single address folder.
Members
Select +, and in Select Entries, select a member or create an address or an address group, click Close.
Use the search bar to look for a member.
Use the pen icon next to the member to edit it.
Excluded members
Enable, and select + to add members to be excluded or create addresses and address groups to be excluded, click Close.
Note: The option is disabled by default and only available when Category is IPv4 Group.
Static route configuration
Enable static route configuration to allow the address group to be used in a static route.
All the members of an address group must have static route configuration enabled.
Note: The option is disabled by default and only available when Category is IPv4 Group.
Comments
Optionally, enter comments about the address group.
- Click OK.
Creating an address group using the CLI example
-
Enter the following commands in the CLI console:
config firewall addrgrp
edit "G Suite" #The address group name.
set uuid 1d22ff2a-fcbf-51ec-442e-9003cab1eecb
set member "gmail.com" "wildcard.google.com"
next
end