execute raidlevel
Use this command to reset the RAID level, partition the disk, and optionally encrypt the disk if supported.
Executing this command will erase all existing data on the RAID array.
Syntax
execute raidlevel <raid-level-option> [encryption <security_key>]
|
Variable |
Description |
Default |
|---|---|---|
|
<raid-level-option> |
Enter a raid level, such as 1 or 10. Click Tab to show optional level values. |
|
|
[encryption <security_key>] |
Encrypt the disk and set the security key. Key value should be a combination of numbers, uppercase letters, lowercase letters, and selected special characters. Its length should be between 8 and 32. Selected special characters are ! # $ % * + , - . : = @ [ ] ^ - _ { } ~. Note: This option is only available in FNDR 1000F, FNDR 2500G and FNDR 3600G. |
|
Support in FortiNDR 1000F
For FortiNDR 1000F, use the CLI command diagnose system raid-status-detail to verify if it supports the encryption feature. In the CLI output, you need to see:
Enterprise Key Management:
=========================
Capability = Supported
If this is not present, please contact Fortinet to obtain a hardware key to enable this feature.