config system interface
Use this command to configure allowed and denied administrative access protocols, up or down administrative status for the network interfaces of FortiNDR.
Syntax
config system interface edit <physical_interface_str> set allowaccess {ping https ssh telnet} set discover {enable | disable} set ip <ipv4mask> set mode {static | dhcp} set speed {auto | 10full | 10half | 100full | 100half | 1000full} set status {down | up} end
Variable |
Description |
Default |
---|---|---|
|
Name of the physical network interface, such as port1. |
|
|
Add one or more protocols to the list of protocols that allow administrative access to FortiNDR through this network interface: ping: Allow ICMP ping responses from this network interface. https: Allow secure HTTP (HTTPS) access to the web-based manager and per-recipient quarantines. ssh: Allow SSH access to the CLI. telnet: Allow Telnet access to the CLI. HTTP and Telnet connections are not secure and can be intercepted by a third party. To reduce risk, enable this option only on network interfaces connected directly to your management computer. |
Varies by network interface. |
|
Allow discovery of the interface on this port. |
|
|
IP address and netmask of the network interface. |
|
|
Interface mode. |
|
|
Speed of the network interface. Some network interfaces might not support all speeds. |
|
|
up enables the network interface to send and receive traffic. down disables the network interface.
|
|