NTP
NTP configuration is handled inside the ntp context
To enter the ntp context, from the base context run:
config system ntp
Available commands
|
Command |
Description |
|---|---|
|
|
Cancels any edits made since entering the context, and returns to the base context |
|
|
Saves changes made since entering the context, and returns to the base context |
|
|
Shows the available commands |
|
|
Show the current configuration, including uncommitted edits |
|
|
Sets the NTP server address list. You may specify up to 10 addresses, space separated. All addresses must be reachable |
|
|
Enable or disable syncing time with specified ntp servers |
|
|
Set the interval to sync in minutes, between 1 and 1440 |
|
u |
Unset the configured value for the specified property, and reset it to default |