Defining the branch template

1. Go to Device Manager > Provisioning Templates > IPsec Tunnel Templates.

2. Right click BRANCH_IPsec_Recommended and click Activate.

3. Provide a template name and fill out the HUB1-VPN1 section as follows:

   Field	Value
   Outgoing Interface	port2
   Local ID	Branch$(branch_id)
   Remote Gateway	Enter the hub WAN IP address.
   Pre-shared Key	Enter a pre-shared key.

   

4. Click OK to save.

5. Edit the newly created template, then edit the HUB1-VPN1 tunnel.

6. Change Routing from Manual to Automatic

7. Under Remote Subnet, enter 172.16.0.0/255.255.255.0.

8. Click OK to save.