Configuring virtual wire pairs

Before you create a virtual wire pair policy, you must create a virtual wire pair.

To configure virtual wire pairs:

1. Go to Policy & Objects > Object Configurations.
2. In the tree menu, go to Normalized Interface > Virtual Wire Pair.
3. In the content pane, click Create New.
4. Complete the following options, and click OK.

   Name	Type a name for the virtual wire pair.
   Interface Members	Select two interface members.
   Wildcard VLAN	Toggle ON to enable wildcard VLANs for the virtual wire pair. When enabled, all VLAN-tagged traffic can pass through the virtual wire pair, if allowed by the virtual wire pair firewall policies. Toggle OFF to disable wildcard VLANs for the virtual wire pair.