Clients Monitor
The client monitor lists information about connected clients. Go to AP Manager > Monitor and select the Clients Monitor tab in the content pane to view the list. Select a specific FortiGate or group in the tree menu to filter the listed clients.
You can search the table by entering a search term in the search field in the toolbar. The visible columns can be adjusted by selecting Column Settings in the toolbar. The following columns are available:
|
SSID |
The SSID that the client connected to. |
|
FortiAP |
The serial number of the FortiAP unit that the client connected to. |
|
IP |
The IP address assigned to the wireless client. |
|
Device |
The type of device that the client is using. |
|
Channel |
The wireless radio channel that is used. |
|
Bandwidth TX/RX |
Client received and transmitted bandwidth, in Kbps. |
|
Signal Strength/Noise |
The signal-to-noise ratio in dBs calculated from signal strength and noise level. |
|
Signal Strength |
The relative signal strength of the AP. |
|
Association Time |
How long the client has been connected to this access point. |
|
Authentication |
The type of authentication used. |
|
Bandwidth RX |
Client received bandwidth, in Kbps. |
|
Bandwidth TX |
Client transmitted bandwidth, in Kbps. |
|
Device OS |
The OS version on the FortiAP. |
|
Host Information |
The host name of the WiFi client, if available. |
|
Idle Time |
The amount of time that the client has been idle. |
|
Manufacturer |
The manufacturer of the client device. |
|
Rate |
The connection rate between the WiFi client and the AP. |
|
Name |
The name of the FortiGate device that the FortiAP is attached to. |