Configuring routing settings
Use this procedure to configure routing settings for FortiIsolator.
Adding a static route
Use this procedure to add a static route.
Steps
- In the FortiIsolator UI, go to Network > System Routing.
- To add a new static route, click Create New.
- Type the destination IP address and subnet mask in the Destination IP/Mask field.
- Type the gateway IP address in the Gateway field.
- In the Device drop-down list, select the interface for the static route.
- Click OK.
Editing a static route
Use this procedure to edit a static route.
Steps
- In the FortiIsolator UI, go to Network > System Routing.
- To edit an existing static route, select the interface in the table, and click Edit.
- Type the destination IP address and subnet mask in the Destination IP/Mask field.
- Type the gateway IP address in the Gateway field.
- In the Device drop-down list, select the interface for the static route.
- Click OK.
Deleting a static route
Use this procedure to delete a static route.
Steps
- In the FortiIsolator UI, go to Network > System Routing.
- To delete a static route, select the interface in the table, and click Delete.
The following image shows an example of the System Routing page.