FortiGate 6000 and 7000 upgrade information

Upgrade FortiGate 6000 firmware from the management board GUI or CLI. Upgrade FortiGate 7000 firmware from the primary FIM GUI or CLI. The FortiGate 6000 management board and FPCs or the FortiGate 7000 FIMs and FPMs all run the same firmware image. Upgrading the firmware copies the firmware image to all components, which then install the new firmware and restart. A FortiGate 6000 or 7000 firmware upgrade can take a few minutes, the amount of time depending on the hardware and software configuration and whether DP or NP7 processor software is also upgraded.

On a standalone FortiGate 6000 or 7000, or an HA cluster with uninterruptible-upgrade disabled, the firmware upgrade interrupts traffic because all components upgrade in one step. These firmware upgrades should be done during a quiet time because traffic can be interrupted for a few minutes during the upgrade process.

Fortinet recommends running a graceful firmware upgrade of a FortiGate 6000 or 7000 FGCP HA cluster by enabling uninterruptible-upgrade and session-pickup. A graceful firmware upgrade only causes minimal traffic interruption.

Fortinet recommends that you review the services provided by your FortiGate 6000 or 7000 before a firmware upgrade and then again after the upgrade to make sure that these services continue to operate normally. For example, you might want to verify that you can successfully access an important server used by your organization before the upgrade and make sure that you can still reach the server after the upgrade and performance is comparable. You can also take a snapshot of key performance indicators (for example, number of sessions, CPU usage, and memory usage) before the upgrade and verify that you see comparable performance after the upgrade.

To perform a graceful upgrade of your FortiGate 6000 or 7000 to FortiOS 7.6.0:

1. Use the following command to set the upgrade-mode to uninterruptible to support HA graceful upgrade:

   config system ha
       set uninterruptible-upgrade enable
   end

   When upgrading from FortiOS 7.4.1 to a later version, use the following command to enable uninterruptible upgrade: config system ha set upgrade-mode uninterruptible end

2. Download the FortiOS 7.6.0 FG-6000F, FG-7000E, or FG-7000F firmware from https://support.fortinet.com.

3. Perform a normal upgrade of your HA cluster using the downloaded firmware image file.

4. When the upgrade is complete, verify that you have installed the correct firmware version.

   For example, check the FortiGate dashboard or use the get system status command.

5. Check the Cluster Status dashboard widget or use the diagnose sys confsync status command to confirm that all components are synchronized and operating normally.