On the FortiGate 7000F, to support FortiLink you must manually set the LACP mode of the fortilink interface to static, for details and more information, see FortiLink support.

New section: GTP with dynamic source port allocation.

Information about the diagnose span-sniffer command that can be used to sniff packets on internal FortiGate 7000F switch and NP7 load balancer interfaces added to What's new for FortiGate 7000F 7.4.1 and Packet sniffing integrated switch fabric (ISF) interfaces.

Corrected information about the interfaces that can be used for FGSP session synchronization, see FortiGate 7000F FGSP.

The command diagnose sys ha set-as-primary has been removed. All information about this command has been removed from this document.

The config vpn ssl settings option tunnel-addr-assigned-method is now available again, see FortiOS features not supported by FortiGate 7000F.

Added a link to more information about FortiGate 7000F SNAT port allocation to Controlling SNAT port partitioning behavior.

New section: FortiGate 7000F and FortiOS Carrier. Removed incorrect information about FortiOS Carrier licensing.