AliCloud SDN connector using access key

FortiOS automatically updates dynamic addresses for AliCloud using an AliCloud SDN connector, including mapping the following attributes from AliCloud instances to dynamic address groups in FortiOS:

• ImageId
• InstanceId
• SecurityGroupId
• VpcId
• VSwitchId
• TagKey
• TagValue

This topic describes one of multiple configuration methods available with this SDN connector type. See the More Links section on the right sidebar for other methods.

To configure AliCloud SDN connector using the GUI:

1. Configure the AliCloud SDN connector:
   1. Go to Security Fabric > External Connectors.
   2. Click Create New, and select AliCloud.
   3. Configure as shown, substituting the access key, secret, and region ID for your deployment. The update interval is in seconds.

      

2. Create a dynamic firewall address for the configured AliCloud SDN connector:
   1. Go to Policy & Objects > Addresses.
   2. Click Create New, then select Address.
   3. Configure the address as shown, selecting the desired filter in the Filter dropdown list. In this example, the address automatically populates and updates IP addresses only for AliCloud instances that belong to the specified security group:

      

3. Ensure that the AliCloud SDN connector resolves dynamic firewall IP addresses:
   1. Go to Policy & Objects > Addresses.
   2. Hover over the address created in step 2 to see a list of IP addresses for instances that belong to the security group configured in step 2:

      

To configure AliCloud SDN connector using CLI commands:

1. Configure the AliCloud SDN connector:

   config system sdn-connector

   edit "ali1"

   set type acs

   set access-key "LTAIKmERWEuEOChg"

   set secret-key xxxxx

   set region "us-west-1"

   set update-interval 30

   next

   end

2. Create a dynamic firewall address for the configured AliCloud SDN connector with the supported AliCloud filter. In this example, the AliCloud SDN connector automatically populates and updates IP addresses only for instances that belong to the specified security group:

   config firewall address

   edit "ali-address-security"

   set type dynamic

   set sdn "ali1"

   set filter "SecurityGroupId=sg-rj9bp5ax5kwy3gqdizqb"

   next

   end

3. Confirm that the AliCloud SDN connector resolves dynamic firewall IP addresses using the configured filter:

   config firewall address

   edit "ali-address-security"

   set type dynamic

   set sdn "ali1"

   set filter "SecurityGroupId=sg-rj9bp5ax5kwy3gqdizqb"

   config list

   edit "10.0.0.16"

   next

   edit "10.0.0.17"

   next

   edit "10.0.0.20"

   next

   end

   next

   end