SNMP queries for hardware session counts
You can use the following MIB fields to send SNMP queries for NP7 IPv4 and IPv6 hardware session counts and session setup rates.
The session rate information depends on the hardware logging configuration:
-
If hardware logging is set to use the NP7 processors for logging, the IPv4 and IPv6 session counts and session setup rates will both be a total of the IPv4 and IPv6rates and appear to be the same in SNMP queries.
-
If hardware logging is set to use the FortiGate CPUs the IPv4 and IPv6 rates will be correct.
Path:FORTINET-FORTIGATE-MIB:fortinet.fnFortiGateMib.fgSystem.fgSystemInfo
OID: 1.3.6.1.4.1.12356.101.4.1
|
Index |
MIB field |
Description |
|---|---|---|
|
.23 |
fgSysNpuSesCount |
NP7 IPv4 session count. |
|
.24 |
fgSysNpuSesRate1 |
NP7 IPv4 session setup rate in the last 1 minute. |
|
.25 |
fgSysNpuSesRate10 |
NP7 IPv4 session setup rate in the last 10 minutes. |
|
.26 |
fgSysNpuSesRate30 |
NP7 IPv4 session setup rate in the last 30 minutes. |
|
.27 |
fgSysNpuSesRate60 |
NP7 IPv4 session setup rate in the last 60 minutes. |
|
.28 |
fgSysNpuSes6Count |
NP7 IPv6 session count. |
|
.29 |
fgSysNpuSes6Rate1 |
NP7 IPv6 session setup rate in the last 1 minute. |
|
.30 |
fgSysNpuSes6Rate10 |
NP7 IPv6 session setup rate in the last 10 minutes. |
|
.31 |
fgSysNpuSes6Rate30 |
NP7 IPv6 session setup rate in the last 30 minutes. |
|
.32 |
fgSysNpuSes6Rate60 |
NP7 IPv6 session setup rate in the last 60 minutes. |