Editing the SD-WAN template for branch devices

You must edit the SD-WAN template for branch devices to adjust the interface members for HUB1.

The HUB1 SD-WAN zone refers to both the FortiGate NVA interfaces. Both IPsec tunnels are added under the same hub to inform the branch devices of the destination, which allows appropriate load balancing.

To edit the SD-WAN template for branch devices:

1. In FortiManager, go to Device Manager > Provisioning Templates > SD-WAN Templates.
2. Double-click the SD-WAN template named SDwan-Branch to open it for editing.
3. Move both interfaces to the same SD-WAN zone. Here the SD-WAN zone is called HUB1.
   1. Under Interface Members, select HUB1, and click Edit.

      

   2. Select both VPN interfaces, and click OK.

      The selected interfaces are displayed for HUB1.