Provisioning targets

The Provisioning Targets page lets you define where fabric managed devices will be provisioned to. After the target is created, the device will appear in the Provision target dropdown when you provision a FortiGate.

To create a provisioning target for FortiGate:

1. Go to Devices and Provisioning > Provisioning Targets.
2. Enable FortiManager Cloud or FortiManager.
3. Click Add.
4. In the Serial Number and IP Address/FQDN fields, enter the FortiManager details. If you are provisioning FortiGate to FortiManagers in a high availability (HA) pair, enter both nodes' serial numbers separated by a comma in the Serial Number field and one IP address (the virtual IP address or hostname) in the IP Address/FQDN field. FortiGate Cloud supports provisioning for FortiManager 7.2 HA.
5. Optionally, enable Pre-run CLI Script to choose a previously configured pre-run CLI script as the default for this FortiManager.
6. Click OK.

To create a provisioning target for FortiAP:

1. Go to Devices and Provisioning > Provisioning Targets.
2. Click the FortiAP tab.
3. Enable FortiSASE.
4. (Optional) Enable External Controller.
5. Click Add.
6. In the IP Address/FQDN fields, enter the address.
7. Click OK.

To create a provisioning target for FortiSwitch:

1. Go to Devices and Provisioning > Provisioning Targets.
2. Click the FortiSwitch tab.
3. Enable FortiSASE.
4. Click OK.

To create a provisioning target for FortiExtender:

1. Go to Devices and Provisioning > Provisioning Targets.
2. Click the FortiExtender tab.
3. Enable FortiSASE.
4. (Optional) Enable External Controller.
   FortiGate Cloud supports provisioning a FortiExtender to a FortiGate when the FortiExtender is operating in LAN extension mode. When LAN extension is enabled, only FortiExtenders running supported FortiOS versions with external LAN functionality are displayed.
5. Click Add.
6. In the IP Address/FQDN fields, enter the address.
7. Click OK.

Assigning provisioning targets

To assign a provisioning target:

1. Go to Devices and Provisioning > Provisioning Targets.
2. Select a device an Unprovisioned device in the list and click Provision.
3. Configure the Serial Number(s) and Portal display time zone.
4. Assign a target from the Provision target dropdown.
5. Click OK.