config router policy6

Description: Configure IPv6 router policies.

config router policy6
  edit <name>
    set input-device <name1>
    set srcaddr <name1>
    set dstaddr <name1>
    set service <name1>, <name2>, …
    set *target <name1>
    set status [enable | disable]
    set comment {string}
unset
next
show
abort
end
delete <name>
purge
move <name1> [before | after] <name2>
show
end

Sample command:

config router policy6
  edit 1
    set input-device lan
    set srcaddr all
    set dstaddr all
    set service ALL
    set target target.wan
    set status enable
    set comment
  next
end

Parameter	Description	Type	Size	Default
input-device	Incoming interface name.	option	-	none
	Option Description lan LAN as the input device. lo Loopback as the input device. lte1 LTE 1 as the input device. wan WAN as the input device. port4 Port 4 as the input device. port1 Port 1 as the input device.
srcaddr	Source address.	option	-	none
	Option Description lan LAN network address. all All the network addresses. none None of the network addresses.
dstaddr	destination address.	option	-	none
	Option Description lan LAN network address. all All the network addresses. none None of the network addresses.
service	Service/service group names.	option	-	none
	Option Description ALL_ICMP ICMP. ALL All. etc Refer to the different services in this command.
target	The PBR's out-going interface and next-hop.	option	-	none
	Option Description target.lan LAN as the target. target.lo Loopback as the target. target.lte1 LTE 1 as the target. target.wan WAN as the target. target.port4 Port 4 as the target. target.Port1 Port 1 as the target.
status	Status of the policy based the routing rule.	option	-	enable
	Option Description enable Enable the policy. disable Disable the policy.
comment	Comment on the policy.	string	1 - 255 characters in length	none