Configure static routing
The table below describes the commands for configuring static routing.
|
CLI command |
Description |
|---|---|
|
config router static |
Enters static route configuration mode. |
|
edit <name> |
Specify the name of the static route. |
|
set status {enable | disable} |
Set the status of the static route:
|
|
set dst <dst> |
Specify the destination IP address and netmask of the static route in the format: |
|
set gateway <gateway> |
Specify the IP address of the gateway. |
|
set distance <distance> |
Specify the administrative distance. The range is 1–255. The default is 1. |
|
set device <device> |
Specify the name of the outgoing interface. |
|
set comment [comment] |
Enter a comment (optional). |
Example static route configuration:
config router static
edit 1
set status enable
set dst 0.0.0.0/0
set gateway 192.168.2.1
set distance 5
set device lan
set comment
next
End