Adding a New Application

Adding your application in the FortiDevSec GUI to perform vulnerability scan testing.

1. Click the App Directory > New Application tab and enter the Application Name. Click Next.
   
   
2. In the Settings panel you can configure the risk rating factors based on questionnaire for this application .
   Note: If you do not configure the risk rating factors then the displayed default settings are applied.
   The following data is associated with the OWASP factors to calculate risk rating for your application.
   • Possible impact in case of a full breach of this application.
   • The application deployment details.
   
   
3. Click Next.
4. You can enable and Add Jira Plugin, configure the Jira cloud server or the on-premise solution and select the project to integrate it with this application.
   
   
5. You can enable and configure FortiDAST scanning.
   1. Enter the target application URL and port number.
   2. Click Validate. Once the URL and license is validated, the DAST license selected is displayed.
   3. Click Next.
      
      

6. After an application is created, success message is displayed.

   • To configure the DAST scan in FortiDAST:
     1. Click DAST Config Link.
     2. FortiDAST configuration page opens in a new tab.
     3. Configure DAST scan as needed. See Configuring FortiDAST Scanner.
   • To download fdevsec.yaml file, click Scanner Config.
     Note: To perform DAST scan, uncomment the dast configuration in fdevsec.yaml file even when FortiDAST asset/URL is configured through GUI plugin.
     

Click Done and your application is listed in the dashboard.