The Interface Mapping page
The interface mapping page is similar to the single conversion, input the proper interface mapping table for each sub-conversion.
- Users can switch the interface mapping table between each sub-conversion.
- If the interface mapping of each conversion is similar, you can click "Apply mapping to all" option to apply the current mapping to all sub-conversions.
- Make sure each interface table maps correctly.
- Click Next to perform bulk conversion.
The highlighted row is unable to make adjustment since the source interface wan1 is used for communicating with the target device.
Convert, Import and restore phase
At this stage, FortiConverter converts the configuration, imports into the target device, stores them, and restores the target device to the original state before proceeding to the next sub-conversion.
All steps will be performed automatically. Please make sure the device is connected as usual, and wait until all steps are completed.
- FortiConverter is installing the configurations onto the target device.
-
- The target device is restored to the default state before processing the next import.
-
- The next sub-conversion continues the process until all the tasks are finished.
|
Please note that the device performs restore and restart the device between each sub-conversion, and each takes 1-2 minutes. |