Fortinet white logo
Fortinet white logo

Known issues

Known issues

The following known issues have been found in FortiController-5000 5.2.10 build 0189. For inquires about a particular bug, please contact Customer Service & Support.

Bug ID Description

854652

When using the config switch fabric-channel trunk command to create a new trunk (or aggregate interface) or edit a trunk that has been previously added, the configuration change is implemented when you press the Enter key after entering the set command to change the configuration. Normally, in the FortiController CLI, configuration changes are not implemented until you enter end to save your changes. This also means that if you make a configuration change to a trunk and enter abort, the change has already been made and entering abort has no effect.

If you need to revert a trunk configuration change that you wanted to cancel with the abort command, you can use the config switch fabric-channel trunk command to manually revert to the correct configuration.

Changing the trunk (aggregate interface) configuration from the GUI is not affected by this issue. On the GUI, changes are not implemented until you select OK to save your changes and you can cancel a configuration change without saving it.

781093

FortiController 5.2.10 supports creating a maximum of 140 trusted hosts. Creating more than 140 trusted hosts is allowed by the CLI, but creating more than 140 trusted hosts can block management access over special management ports to the FortiController and FortiGates in the secondary chassis in an FGCP HA configuration.

Known issues

Known issues

The following known issues have been found in FortiController-5000 5.2.10 build 0189. For inquires about a particular bug, please contact Customer Service & Support.

Bug ID Description

854652

When using the config switch fabric-channel trunk command to create a new trunk (or aggregate interface) or edit a trunk that has been previously added, the configuration change is implemented when you press the Enter key after entering the set command to change the configuration. Normally, in the FortiController CLI, configuration changes are not implemented until you enter end to save your changes. This also means that if you make a configuration change to a trunk and enter abort, the change has already been made and entering abort has no effect.

If you need to revert a trunk configuration change that you wanted to cancel with the abort command, you can use the config switch fabric-channel trunk command to manually revert to the correct configuration.

Changing the trunk (aggregate interface) configuration from the GUI is not affected by this issue. On the GUI, changes are not implemented until you select OK to save your changes and you can cancel a configuration change without saving it.

781093

FortiController 5.2.10 supports creating a maximum of 140 trusted hosts. Creating more than 140 trusted hosts is allowed by the CLI, but creating more than 140 trusted hosts can block management access over special management ports to the FortiController and FortiGates in the secondary chassis in an FGCP HA configuration.