Vendor specific elements can be enabled by SSID and send out information about the FortiAP name, model and serial number. This allows wireless administrator performing site surveys to easily determine the coverage area of a FortiAP. The administrator can slowly move away from a FortiAP while continuously sniffing the beacons to determine if they can still hear from the FortiAP.
Another use case is to ensure that the FortiAP can be correctly identified during post-implementation wireless site surveys. This make troubleshooting and design improvements much easier.
- Go to WiFi & Switch Controller > SSIDs and select the SSID you want to enable Beacon advertising on.
Under WiFi Settings, enable Beacon advertising and select which element(s) you want to advertise:
- Name - The FortiAP name.
- Model - The FortiAP model.
- Serial Number - The FortiAP serial number.
Click OK to save.
config wireless-controller vap edit "dont_connect" set ssid "dont_connect" set pmf enable set passphrase ENC ******** set schedule "always" set quarantine disable set beacon-advertising name model serial-number next end
diag wireless wlac -c wlan dont_connect | grep "beacon advertising" beacon advertising : name model sn
Upon sniffing the air packet, an additional field vendor specific Fortinet can be found in SSID beacon which has name of the advertising FAP (test), model 234F and serial number of 234F.