Filtering report output

You can apply log message filters to reports. You can set up report filters in one of the following areas:

• Settings tab Filters section.
• Layout tab Filters section in the Insert Chart or Chart Properties dialog box. To open this dialog box, click Insert Chart or Edit Chart, or right-click a chart and select Chart Properties.

In the Filters section, the following options are available.

Field	Description
Log messages that match	Available in the Settings tab only. Select All to filter log messages based on all of the added conditions, or select Any of the Following Conditions to filter log messages based on any one of the conditions.
Add Filter	Click to add filters. For each filter, select the field, and operator from the dropdown lists, then enter or select the values as applicable. Filters vary based on device type. Please make sure that the filter being selected matches a field in the logs used by the chart(s) you are seeking to filter.
LDAP Query	Available in the Settings tab only. Click to add an LDAP query, then select the LDAP Server and the Case Change value from the dropdown lists. Use this option to query an LDAP server for group membership. The results of this query is used to filter the report to only match logs for users belonging to that group. You must specify the group name in the filter definition. If you enable LDAP Query, the group name is not used to match the group field in logs. The group name is only used for the LDAP query to determine group membership.

If both chart and report filters are selected for the same report, the chart filter will be used instead of the report filter.