Connect to the FortiAnalyzer-BigData CLI
After configuring the FortiAnalyzer-BigData network, you can use the IP addresses to access the FortiAnalyzer-BigData Main CLI or the Security Event Manager Controller and manage the system.
To connect to the FortiAnalyzer-BigData Main CLI:
-
Establish an SSH connection to the Main Host IP you configured in the set up process.
For the set up process, see the FortiAnalyzer-BigData Getting Started Guide for your appliance on the Fortinet Document Library.
-
Log in using the administrator credentials you created when setting up the administrator account.
If you did not create a new administrator credential, use the default credentials of username
admin
with no password.
To connect to the Security Event Manager Controller:
-
Establish an SSH connection to the Cluster Management IP you configured in the set up process.
For the set up process, see the FortiAnalyzer-BigData Getting Started Guide for your appliance on the Fortinet Document Library.
If the Cluster Management IP is not reachable, you can SSH to the Main CLI first (see To connect to the FortiAnalyzer-BigData Main CLI.) and then SSH to the Controller host or any of the cluster hosts using its internal IP. (For example, to SSH to the Controller host, use
exec ssh root@198.18.1.2
).The IP it is in can be determined by this format:
198.18.{chassis_id}.{blade_id}
where 198.18* is the default internal subnet. -
Log in using the default username
root
and passwordfortinet@123
. -
After establishing a connection, you can use the
fazbdctl
CLI commands to manage the cluster. For more information, see the FortiAnalyzer-BigData CLI Reference on the Fortinet Doc Library.Fortinet strongly recommends that you update the password with the
fazbdctl set password
command.