config load-balance reputation-block-list
Use this command to create a new ip-reputation block list. If enabled, the specified IP address or range of IP addresses will not be allowed to pass through.
Before you begin:
- You must have read-write permission for load balancing feature settings.
Syntax
config load-balance reputation-block-list
config entries
edit <No.>
set status {enable|disable}
set type { ip-netmask|ip-range}
set ip-network <ip&netmask>
set end-ip <ip>
set start-ip <ip>
next
end
|
status |
Enable or disable the exception. You might have occasion to toggle to exception off and on. |
|
type |
|
|
IP/Netmask |
If IP/netmask is selected in the Type field above, specify a subnet using the address/mask notation. |
|
start-ip |
Specify the start of an address range. |
|
end-ip |
Specify the end of an address range. |