config firewall qos-filter6

Use this command to configure QoS rules for IPv6 addresses.

A QoS filter is the policy that assigns traffic to the QoS queue.

Note: The QoS policy feature is not supported for traffic to virtual servers.

Before you begin:

• You must have a good understanding and knowledge of traffic in your network that requires QoS provisioning.
• You must have created the address configuration objects and service configuration objects that define the matching tuple for QoS rules.
• You must have created a QoS queue configuration object.
• You must have read-write permission for firewall settings.

Syntax

config firewall qos-filter6

edit <name>

set destination-address6 <datasource>

set in-interface <datasource>

set out-interface <datasource>

set queue <datasource>

set service <datasource>

set source-address6 <datasource>

set status {enable|disable}

next

end

destination-address6	Destination address object to use to form the matching tuple.
in-interface	Interface that receives traffic.
out-interface	Interface that forwards traffic.
queue	QoS queue that will be used for packets that match the filter criteria.
service	Service object to use to form the matching tuple.
source-address6	Source address object to use to form the matching tuple.
status	Enable/disable the filter.