diagnose debug cmdb

Use this command to set the debug level for CLI commands. The debug messages are returned when you enter CLI commands.

Syntax

diagnose debug cmdb [<level>] <Enter>

<Enter>	If you do not specify a debug level and press Enter, the command displays the current debug level.
<level>	Valid range is 0 to 8, where 0 disables debug logs and 8 generates the most verbose logging.

Example

FortiADC-VM # diagnose debug cmdb 8

After you set the debug level, messages are written to the CLI when you enter commands:

FortiADC-VM # config system interface

FortiADC-VM (interface) # edit 2

Add new entry '2' for node 1

FortiADC-VM (2) # set ip 123

set attribute [4]ip

invalid ip address/mask 123.

data converting failed 4

Command fail. Return code is -39

FortiADC-VM (2) # end

attribute 'type' must be set

fgtlog: added a new entry '2' failed (-56) for "system interface"

Command fail. Return code is -56

FortiADC-VM #