config system address

Use this command to create the IPv4 address objects that you use to specify matching source and destination addresses in policies.

The following policies use address objects:

• Connection limit policies
• Firewall policies
• Link Load Balance policies
• QoS policies

Basic Steps

1. Create address objects.
2. Specify them when you configure your policies.

Before you begin:

• You must have read-write permission for system settings.

Syntax

config system address

edit <name>

set type {ip-netmask | ip-range}

set ip-netmask <ip&netmask>

set ip-min <class_ip>

set ip-max <class_ip>

next

end

type	ip-netmask: address block ip-range: address range
ip-netmask	Specify a subnet using the address/mask notation.
ip-min	Specify the start of an address range.
ip-max	Specify the end of an address range.

Example

FortiADC-docs # config system address

FortiADC-docs (address) # edit TEST-NET-1

Add new entry 'TEST-NET-1' for node 3800

FortiADC-docs (TEST-NET-1) # get

type : ip-netmask

ip-netmask : 0.0.0.0/0

FortiADC-docs (TEST-NET-1) # set ip-netmask 192.0.2.0/24

FortiADC-docs (TEST-NET-1) # next

FortiADC-docs (address) # edit TEST-NET-2

Add new entry 'TEST-NET-2' for node 3800

FortiADC-docs (TEST-NET-2) # set ip-netmask 198.51.100.0/24

FortiADC-docs (TEST-NET-2) # next

FortiADC-docs (address) # edit TEST-NET-3

Add new entry 'TEST-NET-3' for node 3800

FortiADC-docs (TEST-NET-3) # set ip-netmask 203.0.113.0/24

FortiADC-docs (TEST-NET-3) # end

FortiADC-docs #