config load-balance allowlist
Use this command to configure the Geography IP address allowlist.You use the allowlist to permit requests from clients that otherwise might be denied by the Geography IP address block list. For example, you might have a good reason to block requests from the whole address range for a country, except for the addresses for your known customers.
Before you begin:
- You must have read-write permission for load balancing settings.
After you have configured a Geography IP address allowlist, you can specify it in the virtual server configuration.
Syntax
config load-balance geoip-allowlist
edit <name>
set description <string>
set status {enable|disable}
config allowlist-member
edit <No.>
set ip-network <ip&netmask>
next
next
end
|
description |
A string to describe the purpose of the configuration, to help you and other administrators more easily identify its use. Put phrases in quotes. For example: |
|
status |
Enable/disable the list. |
|
config allowlist-member |
|
|
ip-network |
Specify the IP address and CIDR-formatted subnet mask, separated by a forward slash, such as 192.0.2.0/24. Dotted quad formatted subnet masks are not accepted. IPv6 addresses are not supported. |
Example
FortiADC-VM # config load-balance allowlist
FortiADC-VM (allowlist) # edit demo
Add new entry 'demo' for node 2893
FortiADC-VM (demo) # get
description : IP-geo-white-list
status : enable
FortiADC-VM (demo) # set description "Customer ABC."
FortiADC-VM (demo) # config allowlist-member
FortiADC-VM (allowlist-member) # edit 1
Add new entry '1' for node 2897
FortiADC-VM (1) # get
ip-network : 0.0.0.0/0
FortiADC-VM (1) # set ip-network 192.0.2.0/24
FortiADC-VM (1) # end
FortiADC-VM (demo) # get
description : "Customer ABC."
status : enable
== [ 1 ]
FortiADC-VM (demo) # end