config system addrgrp

Use this command to create the IPv4 address groups that you use to specify matching source and destination addresses in policies.

The following policies use address groups:

• Link Load Balance policies

Basic Steps

1. Create address objects.
2. Configure address group objects.
3. Select the address groups when you configure your policies.

Before you begin:

• You must have read-write permission for system settings.
• You must have created IPv4 address objects.

Syntax

config system addrgrp

edit <name>

config member

edit <name>

set address <datasource>

next

end

next

end

address

Specify an IPv4 address object.

Example

FortiADC-docs # config system addrgrp

FortiADC-docs (addrgrp) # edit WAN

Add new entry 'WAN' for node 3806

FortiADC-docs (WAN) # config member

FortiADC-docs (member) # edit 1

Add new entry '1' for node 3808

FortiADC-docs (1) # set address TEST-NET-3

FortiADC-docs (1) # end

FortiADC-docs (WAN) # next

FortiADC-docs (addrgrp) # edit LAN

Add new entry 'LAN' for node 3806

FortiADC-docs (LAN) # config member

FortiADC-docs (member) # edit 1

Add new entry '1' for node 3808

FortiADC-docs (1) # set address TEST-NET-1

FortiADC-docs (1) # next

FortiADC-docs (member) # edit 2

Add new entry '2' for node 3808

FortiADC-docs (2) # set address TEST-NET-2

FortiADC-docs (2) # end

FortiADC-docs (LAN) # end